SafeBOT
Vault Series Boat Cover for 17–19 ft Boats
The Safeboatz Vault Series boat cover fits 17–19 ft hulls up to 96 inches wide. See how the integrated S-hook straps work and check your boat’s fit.
U.S. price $139.99
Safeboatz / Vault Series
11 sewn-in straps with metal S-hooks
If you cover your boat after every outing, it helps to have the straps right where you left them. All 11 blue straps stay sewn to the Vault cover when you take it off. A gated metal S-hook closes each loop, and a metal adjuster takes up the slack.
17–19 ft hull length · 96 in maximum beam · PU-coated 900D polyester
Measure the hull before you choose a cover
Measure from bow to stern along the hull, then measure straight across its widest point. Use the hull length, not the length of the trailer. This size fits 17–19 ft hulls with a beam of up to 96 inches (8 ft).
A high windshield, console or raised fitting uses up fabric. Compare your boat’s profile with the diagram and check that the hem can reach the hull on both sides.
How the Vault straps fasten
Start with the FRONT label at the bow and the two REAR labels at the stern. Take each integrated strap around the trailer frame, bring the gated S-hook back to its receiving loop, then take up the slack with the metal adjuster.
Work around the boat in stages so the tension stays even. The Vault’s sewn top strap runs down the centerline and forks toward the two rear attachment points.
What you’ll handle at the trailer
The blue straps are sewn into the cover with box-X stitching. When you take the cover off, the strap and its adjuster come away with it. That matters if you pack up at the ramp and fit the cover again at home.
The elastic hem holds the lower edge against the hull as you work around the trailer. Reinforced corners take the wear where the fabric bends over the boat.
How the cover sheds rain in storage
The PU coating is on the 900D polyester. Inside, tape covers the seams where the panels are stitched together. The two vents leave a path for air under the cover.
Give the cover a slope over the cockpit so rain can run off. Before folding it into the included bag, let the underside and the webbing dry.
Common questions
What protects the boat during storage?
The black 900D polyester has a polyurethane coating and taped inner seams. Two vents let air circulate under the cover. Support low spots so rain can run off instead of collecting in a pocket.
Is there a separate motor cover?
One bag does both jobs: it stores the folded cover or slips over an outboard while the cover is in use. It measures 29 × 17 × 29 inches. Compare those dimensions with your motor before using it as a cover.
How does it differ from Coast?
Both covers fit the same hull length and beam. Choose Vault if you prefer straps that stay attached and metal S-hooks. Coast has removable straps with plastic side-release buckles.