SafeBOT
Coast Series Boat Cover for 17–19 ft Boats
The Safeboatz Coast Series boat cover fits 17–19 ft hulls up to 96 inches wide. See how the detachable buckle straps work and check your boat’s fit.
U.S. price $99.99
Safeboatz / Coast Series
11 removable straps with side-release buckles
Unclip the blue straps and lift the Coast cover off the boat. The 11 removable straps thread through sewn loops, so you can pack the hardware separately when you put the cover away.
17–19 ft hull length · 96 in maximum beam · PU-coated 900D polyester
Measure the hull before you choose a cover
Measure from bow to stern along the hull, then measure straight across its widest point. Use the hull length, not the length of the trailer. This size fits 17–19 ft hulls with a beam of up to 96 inches (8 ft).
A high windshield, console or raised fitting uses up fabric. Compare your boat’s profile with the diagram and check that the hem can reach the hull on both sides.
How the Coast buckles fasten
Use the FRONT label at the bow and the two REAR labels at the stern to orient the cover. Thread each blue strap through its sewn fabric loop, route it around the trailer frame and close the side-release buckle.
Adjust the straps on both sides in stages to keep the cover centered. When you uncover the boat, release the buckles and store the loose straps with the cover.
Taking the cover off at the ramp
The side-release buckles let you open one strap at a time. You can leave the webbing threaded through its fabric loop while you uncover, or pull it free to pack the straps separately.
The elastic hem helps the cover sit around the hull while you attach the straps. On the next outing, start at the labeled bow and check that the reinforced corners sit over the boat evenly.
Fabric, vents and storage
Look under the cover and you’ll see tape along the stitched seams. The 900D polyester has a polyurethane coating, while the two vents allow air to circulate underneath.
Support the cover over the cockpit so rain can drain. After uncovering, let the fabric and loose straps dry before putting them into the storage bag.
Common questions
What protects the boat during storage?
The black 900D polyester has a polyurethane coating and taped inner seams. Two vents let air circulate under the cover. Support low spots so rain can run off instead of collecting in a pocket.
Is there a separate motor cover?
One bag does both jobs: it stores the folded cover or slips over an outboard while the cover is in use. It measures 29 × 17 × 29 inches. Compare those dimensions with your motor before using it as a cover.
How does it differ from Vault?
Both covers fit the same hull length and beam. Choose Coast if you prefer to unclip and remove the straps. Vault keeps its straps sewn to the cover and uses gated metal S-hooks.